Skip to content
FLANGES & FITTINGS MANUFACTURING · STEEL PIPE SUPPLYinfo@lkpiping.com

LEKE PIPING / NEWS & INSIGHTS

Requesting a Custom Pipe Bend?

Custom pipe bends arranged on a workshop floor

If you need a custom pipe bend, send the drawing with your enquiry. Mark any details that still need confirmation.

A drawing lets you show the bend angle, radius and straight ends in one place. It also gives you a way to identify the dimensions that matter for your installation. A product photograph can help explain the shape, but it does not replace dimensioned requirements.

You can browse our pipe elbows and bends for product context. For a custom requirement, use your drawing and project specification as the starting point.

Start with the dimensions you already know

Include the pipe outside diameter, wall thickness, bend angle and bend radius. If your specification uses nominal size or schedule, include those designations too. State the units on the drawing.

Make clear how the radius is defined. A number labelled only “radius” can leave room for interpretation; mark the reference on the drawing.

Show whether straight ends are required at one end, both ends or neither. Mark their lengths and the points from which they are measured. If a dimension has not been decided, label it “to be confirmed.”

Custom pipe bends arranged on a workshop floor
Different curved profiles and straight-end arrangements in a workshop photograph. Specify the required geometry on your drawing; dimensions cannot be established from this image.

State the material and applicable requirements

Include the material grade and the applicable standard or project specification. “Carbon steel” or “stainless steel” describes a broad category, not the full material requirement for an order.

Attach the relevant section of your project specification where available. If an alternative material or manufacturing approach may be considered, explain who needs to approve it. Resolve proposed changes before they become part of the order.

Point out the details that need attention

If the bend must fit between two existing connection points, identify the dimensions your team needs checked. Include the relevant end-connection details when it connects to another component.

A short note beside the drawing is often enough. For example:

Please review the marked dimensions before quoting. The straight-end length shown at End A still needs confirmation.

Use a note like this when it reflects your actual requirement. For specified end preparation, include the drawing detail rather than relying on a photograph alone.

Open ends of custom pipe bends
Curved pipe pieces with visible end details. This photo illustrates appearance only; specify the required end preparation in the enquiry.

Include inspection and documentation requirements

List the inspection records and documents your project requires when you send the enquiry. If the purchasing specification names a material certificate type, test requirement or inspection stage, include that wording or attach the specification.

State any third-party inspection requirement at the quotation stage so it can be reviewed with the supply scope. Our quality and inspection page provides further information for that discussion.

Add the quantity and delivery details

Include the quantity for each item, the delivery destination and your required delivery date, if known.

For several bend types, use an itemised list and give each drawing a matching reference. This makes it possible to connect each quantity to the correct drawing.

When you revise a drawing, identify the revision in your message. Ask for the quotation to reference the version you want reviewed.

Check what the quotation covers

Before placing the order, compare the quotation with your enquiry. Check the product description, material, dimensions, quantity, inspection requirements and documents. Resolve qualifications, exclusions and anything marked as pending.

If you agreed a change by email, make sure it appears in the final order details. Both sides should be working from the same drawing revision and requirements.

Send your enquiry to LeKe Piping

Send your drawing or product list to info@lkpiping.com. Include the specifications you have and mark any details that still need confirmation.

For a final check before sending, use our piping RFQ checklist and contact details. We’ll review the requirement with you and clarify the information needed for a quotation.

CONTINUE READING

Related articles

Explore more on the topics covered in this article.

Discuss your piping requirements.

Send the product type, size, material, applicable standard and quantity with your enquiry.

Send your RFQ →